Required equipment, Equipment shipping with the card, User-supplied equipment – Rockwell Automation 825-P Modular Protection System for Motors User Manual User Manual
Page 116: Wiring, Use static control precautions, Connect a devicenet cable to the network
116
Rockwell Automation Publication 825-UM004D-EN-P - November 2012
Chapter 9 825-PDN DeviceNet Communication Card
Required Equipment
Equipment Shipping with the Card
When you unpack the card, verify that the package includes:
•
One DeviceNet communication card
•
One five-pin linear DeviceNet plug
•
Two labels that the installer affixes to the 825-P Modular Protection
System, one to the top and one to the back panel
•
825-P Option Card installation instructions
User-Supplied Equipment
•
Small slotted screwdriver (0.6 x 3.5 mm)
•
DeviceNet cable, a thin cable with outside diameter of 6.9 mm (0.27 in.),
is recommended
•
Configuration tool (e.g., RSNetWorx for DeviceNet)
•
Computer with an installed DeviceNet communication adapter
•
825-P User Manual
Wiring
1.
Remove power from the DeviceNet network and 825-P Modular
Protection System relay
2.
Use static control precautions
3.
Connect a DeviceNet cable to the network
4.
Terminate the bare leads of the DeviceNet cable to the 5-pin linear plug
as illustrated in Figure 40