Rockwell Automation 825-P Modular Protection System for Motors User Manual - Manual (Page 257)

Rockwell Automation Publication 825-UM004D-EN-P - April 2012 257
DeviceNet Information Chapter E
Parameter Object - CLASS
CODE 0x000F The following class attributes are supported for the Parameter Object:
There is a standard set of instances reserved (1…100) for 825-PDN
DeviceNet Communication Card specific parameters. These instances are
followed by the motor relay parameters.
Refer to AppendixB of the 825-P Modular Protection System User Manual
(publication 825-UM004) for details of the individual motor relay parameter
instances.
The following services are implemented for the Parameter Object:
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT
2 Get Max Instance UINT
8 Get Parameter Class Descriptor WORD
9 Get Configuration Assembly Instance UINT 0
Service Code
Implemented for:
Service Name
Class Instance
0x0E Yes Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single
0x01 No Yes Get_Attributes_All