Installation and wiring, Chapter, Introduction – Rockwell Automation 193-EPRB Profibus Side Mount Module for the E1 Plus Overload Relay User Manual User Manual
Page 5
Chapter
1
Installation and Wiring
Introduction
The purpose of this chapter is to provide the necessary instructions to successfully install a
193-EPRB PROFIBUS Module to an E1 Plus Overload Relay and properly connect to a
PROFIBUS network.
ATTENTION
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from
contaminants.
ATTENTION
The side mount module contains ESD (electrostatic discharge) sensitive
parts and assemblies. Static control precautions are required when
installing, testing, servicing, or repairing this assembly. Component
damage may result if ESD control procedures are not followed. If you
are not familiar with static control procedures, refer to Rockwell
Automation publication 8000-4.5.2, “Guarding Against Electrostatic
Damage”, or any other applicable ESD protection handbook.
ATTENTION
The purpose of this document is to serve as a guide for proper
installation. The National Electrical Code and any other governing
regional or local code will take precedence. Rockwell Automation cannot
assume responsibility for the compliance or proper installation of the
side mount module or associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are ignored during installation.
ATTENTION
An incorrectly applied or installed side mount module can result in
damage to the components or reduction in product life. Wiring or
application errors such as supplying incorrect or inadequate supply
voltage, or operating/storing in excessive ambient temperatures may
result in malfunction of the product.
ATTENTION
Only personnel familiar with the side mount module and associated
machinery should plan to install, set up, and maintain the system. Failure
to comply may result in personal injury and/or equipment damage.
ATTENTION
This is a Class A product. In a domestic environment, this product may
cause radio interference, in which case, the user may be required to take
adequate measures.