Rockwell Automation 150 USE MN/SMC DIALOG + CONTROLLER - Manual (Page 100)

7-16 Options
Figure 7.12 Typical Wiring Diagram for Applications Requiring an Isolation
Contactor
① Customer supplied.
② Refer to the controller nameplate to verify the rating of the control power input voltage.
④ Slow Speed or Accu-Stop.
Note: Refer to Chapter 3 for typical power circuits.
Stop ➀
IC ➀
Control Power ➁
Option Command ➀ ➂
Start ➀
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
Internal
Auxiliary
Contacts
Auxiliary contacts set
for Normal
SMC Dialog Plus
Control Terminals