Rockwell Automation 150 USE MN/SMC DIALOG + CONTROLLER - Manual (Page 90)

7-6 Options
Figure 7.2 Typical Retrofit Wiring Diagram
① Customer supplied.
② Overload protection should be disabled in the SMC Dialog Plus controller.
③ Refer to the controller nameplate to verify the rating of the control power input voltage.
④ Soft Stop, Pump Stop, or Brake.
Note: Refer to Chapter 3 for typical power circuits.
Stop ➀
OL ➀ ➁
M ➀
Control Power ➂
Option Stop ➀ ➃
Start ➀
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
Internal
Auxiliary
Contacts
Auxiliary contacts set
for Normal
SMC Dialog Plus
Control Terminals