Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 101)

Appendix
B
Module Parameters
Appendix B provides information about the EtherNet/IP-to-SCANport
module parameters.
The parameters in the module are numbered consecutively. However,
depending on which configuration tool you use, they may have different
numbers.
Topic Page
About Parameter Numbers B-1
Parameter List B-1
About Parameter Numbers
Configuration Tool Numbering Scheme
• DriveExplorer
• DriveExecutive
The module parameters begin with parameter 01. For
example, Parameter 01 - [SCANport Adapter] is
parameter 01 as indicated by this manual.
• Explicit Messaging
Refer to Chapter 6 , Using Explicit Messaging , and
Appendix C , EtherNet/IP Objects , for details.
Parameter List
Parameter
No. Name and Description
Details
01 [SCANport Adapter]
Displays the port to which the module is
connected. Default: 7
Minimum: 0
Maximum: 7
Type: Read Only
02 [BOOTP]
Configures the module to use BOOTP so that you
can set its IP address, subnet mask, and gateway
address with a BOOTP server. Default: 1 = Enabled
Values: 0 = Disabled
1 = Enabled
Type: Read/Write
Reset Required: Yes