Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 95)

Viewing the Module’s Web Pages 8-7
The Configure E-mail Notification web page contains selections and
data fields for configuring the module to automatically send e-mail
messages to desired addresses when selected types of events occur. By
default, this configuration is not protected. After configuration, the
settings can be protected by setting the Parameter 65 - [Web Features]
E-mail Cfg Bit 0 value to “0” (Disabled). To change a protected
configuration, it must first be unprotected by setting the E-mail Cfg Bit 0
value back to “1” (Enabled). For more information, see
Chapter 3 ,
Setting Web Features Access .
Figure 8.4 Example of Configure E-mail Notification Web Page
To configure e-mail notification
1. Click the SCANport product’s desired fault and/or warning check
boxes you want to occur that will send e-mail notification:
– If you only want e-mail notification when specific faults or warnings
occur, click this radio button and type their numbers in the box.
– If you only want e-mail notification when all faults or warnings
except specific ones occur, click this radio button and type their
Configure E-mail Notification Web Page