Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 21)

Installing the Module 2-3
Panel or DIN rail mount the module before connecting the module to the
network and drive.
Minimum Spacing
1203-EN1’s can be zero-stacked (side-by-side mounting). Allow 75 mm
(3 in.) of space on the bottom of the module for cable entry. Allow at
least 85 mm (3.2 in.) of enclosure clearance depth to accommodate the
module.
Panel Mounting Using the Dimensional Drawing
Mount the module to a panel using two M4 or #8 panhead screws
(supplied separately).
Figure 2.2 Panel Mounting Dimensions
Mounting the Module
!
ATTENTION: Risk of equipment damage exists. During panel or
DIN rail mounting, be sure that all debris (metal chips, wire strands,
etc.) is kept from falling into the module enclosure. Debris that falls
into the enclosure could cause damage on power up.
96,3
(3.79)
85,3
(3.36)
∅ 4
(0.16)
mm
(in.)
PORT
MOD
NET A
NET B
1203-EN1
EtherNet/IP to SCANport
10/100 Mbps