Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 27)

Chapter
3
Configuring the Module
Chapter 3 provides instructions and information for setting the
parameters in the module.
For a list of parameters, refer to Appendix B , Module Parameters . For
definitions of terms in this chapter, refer to the Glossary .
The EtherNet/IP-to-SCANport module stores parameters and other
information in its own non-volatile memory. You must, therefore, access
the module to view and edit its parameters. The following tools can be
used to access the module parameters:
Topic Page
Configuration Tools 3-1
Using DriveExplorer Software 3-2
Using BOOTP 3-3
Setting the IP Address, Subnet Mask, and Gateway Address 3-5
Setting the Data Rate 3-7
Setting the I/O Configuration 3-7
Setting the Reference Adjustment 3-8
Selecting Master-Slave or Peer-to-Peer 3-9
Setting a Fault Action 3-13
Setting Web Features Access 3-15
Resetting the Module 3-16
Viewing the Module Configuration 3-17
Configuration Tools
Tool Page
DriveExplorer Software (version 4.03 or higher) 3-2
BOOTP Server (for setting IP address, subnet
mask, and gateway address only) 3-3