Rockwell Automation 1791-XXXX Discrete I/O AC and DC Block I/O Input and Output Modules - Manual (Page 32)

Installing Block I/O
Chapter 3
3-13
Connections
1791-0A32 Series B Connector/Terminal
Connections
Designation Description Left Conn. Right Conn.
P
L1 ac hot 1
Power
Connections
N ac neutral 3
Connections
GND Chassis ground 2 1
R t I/O
BLU Blue wire - RIO 6
Remote I/O
Connections
CLR Clear wire - RIO 8
Connections
SHD Shield - RIO 7
I/O Connections
PLC: out 00 thru 07
SLC: out 00 thru 07
PLC: Output 00 thru 07
SLC: Output 00 thru 07
16, 18, 20,
22, 24, 26,
28, 30
Output
L1-1 L1 output supply 10, 12, 14 2
Output
(G) 6
PLC: out 10 thru 17
SLC: out 08 thru 15
PLC: Output 10 thru 17
SLC: Output 08 thru 15
15, 17, 19,
21, 23, 25,
27, 29
L1-2 L1 output supply 9, 11, 13 3
PLC: out 00 thru 07
SLC: out 00 thru 07
PLC: Output 00 thru 07
SLC: Output 00 thru 07
15, 13, 11, 9,
7, 5, 3, 1
Output
L1-3 L1 output supply 17, 19, 21 4
Output
(G + 1) 7
PLC: out 10 thru 17
SLC: out 08 thru 15
PLC: Output 10 thru 17
SLC: Output 08 thru 15
16, 14, 12,
10, 8, 6, 4, 2
L1-4 L1 output supply 22, 20, 18 5
Not used
For internal test only;
not for customer use.
4, 5 29, 27, 26
No Conn
No internal connection;
customer can use.
30, 28, 25,
24, 23
1 Connect chassis ground to equipment grounding stud. These are not internally connected.
2 Terminals 10, 12 and 14 must be externally connected by customer to accommodate total amperage.
3 Terminals 9, 11 and 13 must be externally connected by customer to accommodate total amperage.
4 Terminals 17, 19 and 21 must be externally connected by customer to accommodate total amperage.
5 Terminals 18, 20 and 22 must be externally connected by customer to accommodate total amperage.
6 OUT (G) = output module group (one word).
7 OUT (G + 1) = output module group plus one word.