Wiring the blocks – Rockwell Automation 1757-SWKIT5000 Getting Started with ProcessLogix R500.1 Quick Start User Manual
Page 19
Advertising
Getting Started with ProcessLogix R500.1 19
Publication 1757-QS500A-EN-P - October 2002
Wiring the Blocks
Adjust your blocks to look similar to the window below.
1. Double-click the source wire. The cursor changes to a “+”.
2. Click the destination wire.
IMPORTANT
The Numeric block you created enables you to simulate a control loop.
For this loop to work properly, do not wire the AICHANNEL block.
TIP
For additional wire segments as you draw your wire,
click the left mouse button.
Advertising