Rockwell Automation 1757-SWKIT5000 Getting Started with ProcessLogix R500.1 Quick Start - Manual (Page 4)

4 Getting Started with ProcessLogix R500.1
Publication 1757-QS500A-EN-P - October 2002
Sample ProcessLogix Configuration
Starting the Software
In this section, we explain how to start:
• The ProcessLogix R500.1 Server software
• Control Builder software
Verifying ControlNet nodes and I/O modules
You should verify the ControlNet nodes and the I/O modules you will use in your system.
For purposes of illustration, we use two ControlNet nodes:
1. ControlNet module with address 1 at slot 0 in the chassis.
To set the node address, adjust the rotary switches on top of the module. See the
schematic on the right side of the module for a guide to selecting the address.
TIP
If the LED on the front of the ControlNet module reads NET ERR,
no other ControlNet devices are present on the network.