Rockwell Automation 1785-Lx0C15 ControlNet PLC-5 Programmable Controllers Quick Start - Manual (Page 12)

Publication 1785-QS006C-EN-P - April 2002
1-2 Before You Begin
Identify the Processor’s Front Panel Components
These pictures show the ControlNet PLC-5 processor front panel
components.
Battery Status Indicator
Processor RUN/FAULT
Status Indicator
Force Status Indicator
Channel 0 Communication
ACTIVE/FAULT Status
Indicator
Memory Module Space
Battery Compartment
Keyswitch
Channel 0
DH+ Programming Terminal
Connection to Channel 1A
Channel 2 ControlNet
Status Indicators
Channel 2
ControlNet I/O Status Indicator
ControlNet Network Access
Port
Channel 1 Status Indicators
Channel 1A
Channel 1B
Memory Module Space
Battery Compartment
Channel 0
Keyswitch
ControlNet I/O Status Indicator
Channel 2 ControlNet
Status Indicators
ControlNet Network Access Port
Channel 2
Channel 1 Status Indicators
DH+ Programming Terminal
Connection to Channel 1A
Channel 1A
Channel 1B
Battery Status Indicator
Processor RUN/FAULT
Status Indicator
Force Status Indicator
Channel 0 Communication
ACTIVE/FAULT Status
Indicator
PLC-5/20C Processor
PLC-5/40C and -5/80C Processors
ControlNet Redundant Media Ports - BNC; dedicated
1
1
1
Wrist strap
!
ATTENTION: Make sure you understand the anti-static environment.
The processor is shipped in a static-shielded container to guard against
electrostatic damage. Electrostatic discharge can damage integrated
circuits or semiconductors in the processor module if you touch
backplane connector pins. It can also damage the module when you set
configuration plugs or switches inside the module. Avoid electrostatic
damage by observing the following precautions.
• Remain in contact with an approved ground point while handling the
module (by wearing a properly grounded wrist strap).
• Do not touch the backplane connector or connector pins.
• When not in use, keep the module in its static-shielded container.