Rockwell Automation 1785-CHBM ControlNet PLC-5 Hot Backup System User Manual - Manual (Page 2)

Important User Information Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been taken
to assure that each application and use meets all performance and safety
requirements, including any applicable laws, regulations, codes and
standards. In no event will Rockwell Automation be responsible or liable
for indirect or consequential damage resulting from the use or application
of these products.
Any illustrations, charts, sample programs, and layout examples shown in
this publication are intended solely for purposes of example. Since there
are many variables and requirements associated with any particular
installation, Rockwell Automation does not assume responsibility or
liability (to include intellectual property liability) for actual use based
upon the examples shown in this publication.
Allen-Bradley
TM
publication SGI-1.1, Safety Guidelines for the
Application, Installation and Maintenance of Solid-State Control
(available from your local Rockwell Automation office), describes some
important differences between solid-state equipment and
electromechanical devices that should be taken into consideration when
applying products such as those described in this publication.
Reproduction of the contents of this copyrighted publication, in whole or
part, without written permission of Rockwell Automation, is prohibited.
Throughout this publication, notes may be used to make you aware of
safety considerations. The following annotations and their accompanying
statements help you to identify a potential hazard, avoid a potential
hazard, and recognize the consequences of a potential hazard
:
PLC-5 is a registered trademark of Rockwell Automation, Inc.
Allen-Bradley, ControlLogix, ControlBus, Data Highway Plus, FLEX I/O, RSLinx, RSLogix, RSNetWorx, PLC-5/40 and PLC-5/80 are trademarks of
Rockwell Automation, Inc.
ControlNet is a trademark of ControlNet International, Ltd.
DeviceNet is a trademark of the Open DeviceNet Vendor Association.
Ethernet is a registered trademark of Digital Equipment Company, Intel and Xerox Corporation.
WARNING
!
Identifies information about practices or circumstances
that can cause an explosion in a hazardous
environment, which may lead to personal injury or
death, property damage, or economic loss.
ATTENTION
!
Identifies information about practices or circumstances
that can lead to personal injury or death, property
damage, or economic loss.
IMPORTANT
Identifies information that is critical for successful
application and understanding of the product.