Rockwell Automation 1785-ENET PLC-5 Ethernet Interface Module Installation Instructions - Manual (Page 15)

PLC-5 Ethernet Interface Module 15
Publication 1785-IN019B-EN-P - January 2007
Before You Begin
Follow these directions before installing your module:
1. Check your Ethernet interface module package.
2. Make certain that you have the following items:
If any items are missing or incorrect, contact your local distributor or Rockwell Automation
representative.
3. Locate and record the Ethernet hardware address.
Your module is assigned an Ethernet hardware address at the factory. Look for this
address in the back, lower corner of your module, or in the channel 3A configuration
dialog in RSLogix 5 programming software.
Quantity Description
1 1785-ENET Ethernet Interface Module
1 Connector kit containing 1 PLC-5 controller 58-pin connector header
1 Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1
1 PLC-5 Ethernet Interface Module Installation Instructions, publication 1785-IN019
Ethernet hardware
address label
Ethernet Hardware
Address Label