Connect the module to the controller – Rockwell Automation 1785-ENET PLC-5 Ethernet Interface Module Installation Instructions User Manual
Page 18
Advertising
18 PLC-5 Ethernet Interface Module
Publication 1785-IN019B-EN-P - January 2007
Connect the Module to the Controller
1. Align the pins and holes on the module to those on the connector header.
2. Press the module into the connector header.
3. Tighten the screws.
IMPORTANT
Make certain you carefully align the pins and holes together before you press
the connector header into the controller. Improper alignment will bend the
connector header pins.
Advertising