Rockwell Automation 1785-ENET PLC-5 Ethernet Interface Module Installation Instructions - Manual (Page 16)

16 PLC-5 Ethernet Interface Module
Publication 1785-IN019B-EN-P - January 2007
Parts List
Required Tools
The 1785-ENET is a modular component of the 1771 I/O system requiring a properly
installed system chassis. Refer to Universal Chassis I/O Installation Instructions, publication
1771-IN075, for detailed information on an acceptable chassis along with proper installation
and grounding requirements. Limit the maximum adjacent slot power dissipation to 10 W.
Install the Module
Follow these directions to install the module:
1. Attach the connector header to the controller.
2. Connect the module to the controller.
WARNING
If you connect or disconnect the communications cable with power applied to
this module or any device on the network, an electrical arc can occur. This could
cause an explosion in hazardous location installations.