Rockwell Automation 1785-ENET PLC-5 Ethernet Interface Module Installation Instructions - Manual (Page 17)

PLC-5 Ethernet Interface Module 17
Publication 1785-IN019B-EN-P - January 2007
3. Install the combination into the chassis.
Attach the Connector Header to the Controller
With grounding wrist strap attached to your wrist, follow these steps:
1. Locate the controller’s connector header port.
2. Push the exposed pins into the holes on the controller.
3. Attach the module to the end of the connector header.
IMPORTANT
If your power supply is already installed in the chassis, be sure the power
supply is OFF before you install the module. If you install the module with
power ON, you will damage the module.
IMPORTANT
Make certain you carefully align the pins and holes together before you press
the connector header into the controller. Improper alignment will bend the
connector header pins.