Rockwell Automation FactoryTalk Historian ME 2.2 Quick Start Guide - Manual (Page 23)

C
OLLECTING
D
ATA
19
•
• •
Note: If a large amount of data is being transferred from the Controller to
the module when the module is going through an initial bootup, please
wait about five to ten minutes before trying to access the FactoryTalk
Historian ME web interface.
Create Points
After the Add Points Wizard searches the ControlLogix processors
and successfully retrieves the matching tags based on the criteria set
in the Discover Tags operation, you can then use the generated tags
to create the corresponding points in FactoryTalk Historian ME.
The Search Results table contains the following information.
Column Name Column Description
Select This column displays checkboxes that
allow you to select or clear tags. Click the
All/None checkbox below the table to
select or clear all tags.