Rockwell Automation 1748 DataSite Configured Panel Installation Instructions - Manual (Page 33)

33 Publication 1748-IN001B-EN-P - May 2009
Chapter
6
Troubleshooting
You can use this chapter as a diagnostic tool to aid in the troubleshooting of
the DataSite configured panel. A table and a step-by-step guide are provided.
The assumption has been made that the DataSite configured panel had been
properly installed and operating prior to the occurrence of a fault.
Troubleshooting requires a clear definition of the problem based upon the
system fault symptoms. Defining the problem clearly and knowing the system
status or operating conditions prior to the problem will narrow the scope of
the troubleshooting. For example, ask questions such as the following:
• Was the system operating normally before the fault occurred?
• Were the batteries charged?
• Was there adequate sunlight for the solar panel?
Field Repairs and
Replacement Procedures
Before servicing the DataSite configured panel, remove all power sources and
ensure the environment is clear of all hazards including explosive gases.
Service on the DataSite configured panels should be performed by personnel
familiar with the DataSite configured panel and its functionality. Read the
DataSite Installation Instructions, publication
1758-IN001 , in its entirety
before servicing the panel or field supplied components connected to it.
ATTENTION
Troubleshooting in a hazardous location must be done by a
qualified field personnel. Additional procedures may be
required depending on the location and the presence of a
hazardous atmosphere. Refer to NFPA 70B, Recommended
Practice for Electrical Equipment Maintenance for Servicing
Guidelines.
IMPORTANT
Replacement of DataSite configured panel parts must be
completed by a qualified person. Installation of a replacement
component other than those specified is not recommended and
will violate the Class I Div. 2 panel listing. For proper
functionality, components should only be replaced with
Rockwell approved replacement components.