Rockwell Automation 1748 DataSite Configured Panel Installation Instructions - Manual (Page 51)

51 Publication 1748-IN001B-EN-P - May 2009
Appendix
C
Configuring the ‘ON’ Push Button for the
Human-machine Interface
Programming the ‘ON’ Push
Button The DataSite controller can be used to control the human-machine interface
(HMI) and must be programmed before the HMI will turn on. Included is a
sample program that can be used to program the DataSite controller to
activate the HMI.
This programming can be completed using the DataSite Tools software that
comes with the DataSite controller. For more information on programming
the DataSite controller, refer to the DataSite Software User Manual,
publication
1758-UM002 .
The DataSite configured panel, when equipped with a HMI, is pre-wired from
the factory with the ‘ON’ push button for the HMI wired to the DI0 input of
the DataSite controller. The HMI is then turned on via a relay which is
controlled by the output DO0 of the DataSite controller. The wiring diagram
shipped with your DataSite configured panel shows these connections.