Rockwell Automation 1732E-IB16M12SOEDR EtherNet/IP ArmorBlock supporting Sequence of Events - Manual (Page 45)

Publication 1732E-UM002A-EN-P - March 2010
Configure the Module Using RSLogix 5000 37
Download Your
Configuration After you write configuration for your module, the module does not use this
configuration until you download it to the owner-controller. The download
transfers the entire program to the controller, overwriting any existing
program.
Download module configuration as shown below.:
Depending on your application, a variety of RSLogix 5000 software screens
may appear to choose a path to your ControlLogix controller and to verify the
download. Navigate those screens as best fits your application.
This completes the download process.
Edit Your Configuration After you have set configuration for a module, you can review and change your
choices. You can change configuration data and download it to the controller
while online. This is called dynamic reconfiguration.
Your freedom to change some configurable features, though, depends on
whether the controller is in Remote Run Mode or Program Mode.
The editing process begins on the main page of RSLogix 5000
A. Click here to see the
pull-down menu.
B. Click download.
IMPORTANT
Although you can change configuration while online, you must
go offline to add or delete modules from the project.
A. Right-click on the module.
B. Select Properties