Rockwell Automation 4100 ALEC AXIS LINK ENCODER CONVERTER - Manual (Page 43)

Publication 4100-5.3 - June 1999
Setup 35
10. Download the diagram.
Once AxisLink is enabled, the AL LED should be green. If the AL LED
is red, reset the ALEC by pressing the Reset button on the front panel
of the ALEC box. If the AL LED stays red after re-setting, check the
cabling and termination to make sure all of the wiring is done
properly. If it remains red, call Allen-Bradley Technical Support.
For more information on AxisLink and how to use it with the ALEC
see the “Using AxisLink” chapter of the GML Commander Reference
Manual (publication 4100-5.3).
IMPORTANT
AxisLink is not enabled until the diagram is downloaded.