5" lcd display and keypad module, Insert the lcd module, Remove the lcd module – Rockwell Automation 2080-LC10-12DWD Micro810 Programmable Controllers User Manual User Manual
Page 62
54
Rockwell Automation Publication 2080-UM001D-EN-E - September 2012
Chapter B About Accessories
1.5" LCD Display and Keypad Module
This module (2080-LCD) also functions as a backup memory module for the
Micro810 controller.
This module offers an affordable and simple method of viewing status and
configuring the Micro810 Controller. With this LCD module, you can also
modify core Smart Relay function blocks.
The LCD Display instructions can be used to display custom messages as well as
to read keystrokes.
This module may be inserted or removed when power is applied to the controller,
but only in non-hazardous locations. Be sure that power is removed or the area is
nonhazardous before proceeding.
Insert the LCD Module
1. Remove blank cover plate.
2. Push in the LCD module until it latches on the top and bottom.
Remove the LCD Module
1. Squeeze the top and bottom latches, then pull out the top first, then the
bottom.