Rockwell Automation 2080-LC10-12DWD Micro810 Programmable Controllers User Manual - Manual (Page 75)

Rockwell Automation Publication 2080-UM001D-EN-E - September 2012 67
Quickstarts Appendix C
Navigate the LCD Display
The following sections enable the user to configure and test each of the eight
Smart Relay (SR) Functions available to the Micro810 controller.
Configure Count-Up (CTU)
This quickstart shows you how to configure the Count Up (CTU)
function block.
1. Power up the Micro810 controller.
The Micro810 splash screen briefly appears after power up.
Micro810 splash screen
Appears briefly upon
controller power up
Language
Allows user to select English,
Chinese, French, Spanish, Italian
Navigation buttons
Allows user to
navigate, select,
confirm, and undo
selection
Communication Status
A flashing square indicates Micro810 controller
has communication with a PC through USB port
User display
A filled square indicates that a user has
programmed a user-defined screen using
LCD instructions
Password activated
A button sign indicates password protection for LCD
operation is activated. For example, a user could change
from Run mode to Program mode using LCD buttons. Note
that this password is for LCD access only. The controller
lock password that is configured through Connected
Components Workbench will not unlock the LCD.
Operation mode
Indicates whether the controller is in Program Mode,
Run Mode, or Idle Mode. The LCD goes into IDLE mode
when the Suspend function block is executed. During
Suspend function block execution, the Micro800
controller remains in RUN mode but execution is
suspended indefinitely. In this case, RUN LED is set off
to indicate that program scan is idle and “IDLE” mode is
indicated in the LCD.
Main Menu
Provides access to features and functions such as Mode
Switch, SR Function, Variables, I/O status, Advanced Set,
and Security.
To go to this screen from the I/O status window or a user-
defined window, press the ESC + OK buttons at the
same time.