Rockwell Automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL - Manual (Page 14)

Chapter 3
Installing the Bulletin 2705 Keypad Module
3–3
Figure 3.1 shows recommended spacing for modules inside the NEMA
enclosure.
Figure 3.1
Spacing for Modules inside the NEMA Enclosure
A
A
B
B B
B
Recommended spacing:
A= 6“ (15cm) from lower edge of top cutout to upper edge of lower
cutout
B= 1“ (2.5cm) from outside edge of mounting flange
Depth of enclosure = 8“ (20cm) or more.
Mounting tabs are built into the module. After you slide the module into the
enclosure, the tabs secure the module to the enclosure. See Figure 3.2. The
installation procedure is listed on the following page.
Figure 3.2
Mounting Tabs and Gasket
Mechanical Installation