Rockwell Automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL - Manual (Page 15)

Chapter 3
Installing the Bulletin 2705 Keypad Module
3–4
To install the module, follow these guidelines:
Step 1 - Cut an opening in the panel approximately 5.86” (149mm) H x
8.61” (219mm) W. See Figure 3.3.
Figure 3.3
Mounting Dimensions of the Module
Step 2 - Drill six 0.312” (7.6mm) diameter holes for the top and bottom
mounting brackets. A template is provided with the module to
assist in this operation.
Step 3 - Slide the module through the opening. The mounting tabs will help
seat the module tightly against an .062” (1.6mm) to .125” (3.2mm)
thick enclosure.