Rockwell Automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL - Manual (Page 17)

Chapter 3
Installing the Bulletin 2705 Keypad Module
3–6
Connect the Keypad Module to the scanner module with Allen–Bradley I/O
cable (Catalog No. 1770–CD) or Belden #9463.
Refer to Publication 1770–4.1 for detailed grounding and wiring guidelines.
The user’s manual or product data sheet for your scanner module will also
provide cabling information.
Important: When first installed, the Keypad Module may misinterpret the
hardware configuration if the DIP switch settings are not entirely correct. If
the FAULT indicator flashes after installation, verify the DIP switch settings
and recycle power to clear the fault.
A connector plug is provided with each Keypad Module. Wire the connector
to the I/O cable according to Figure 3.5 below.
Figure 3.5
Wiring Connections for the Communications Cable
CLEAR
BLUE
SHIELD TWIN–AXIAL CABLE
2705 MODULE
The Belden twin–axial cable is the link that ties the Bulletin 2705
RediPANEL Modules to the Remote I/O communications. It is to be wired
from the mating connector of the user’s scanner module to the mating
connector of the 2705 modules.
MATING CONNECTOR
Connecting a Scanner Module