Rockwell Automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL - Manual (Page 40)

Chapter 7
Programming
7–2
The PLC–5 programming examples given on the following pages are based
on the system configuration listed below.
Note – System configuration may vary for different applications.
1. A 1784–T45 Portable Terminal
2. A 1785–LT PLC–5/15 Processor (Ser. B Rev. H, Set for Scanner Mode)
3. A 1771–P4 Power Supply
4. A 1771–A1B 4 slot chassis
5. A 2705–K11C1 RediPANEL Keypad Module (Ser. B Rev. E)
The DIP switches on the Keypad Module have been set to:
A. Rack 2, Module Group 0
B. 57.6k Baud Rate
C. Destination Bits - Enabled
D. Integer Data Type
E. Last Device
F. Rack Size - 1/2
G. Stored Message and Split Screen - Enabled
H. Keyboard Style - “AT”
I. Dest and SMD Format – Tracking
Prior to entering the sample program into the PLC–5, four messages were
entered into the Keypad Module. The messages are as follows:
MSG.#001 = ”C5.1 ACC.=”
MSG.#002 = "C5.1 PRE.="
MSG.#003 = "16 CHARACTER MSG."
MSG.#004 = "T4:0 PRE ="
PLC-5 Programming Examples
System Configuration