Rockwell Automation 2705 REDIPANEL KEYPAD MODULE USER MANUAL - Manual (Page 38)

Chapter 6
Operating Modes
6–8
The editing commands are single key strokes:
Left arrow (
←
) - Move cursor one position to the left.
Right arrow(
→
) - Move cursor one position to the right.
Down arrow(
↓
) - Decrement number of message to be created or
edited.
Up arrow(
↑
) - Increment number of message to be created or
edited.
Control–B - Set message FLASH attribute.
Control–D - Delete message and return to run mode.
Control–F - Display number of free messages.
Control–R - End edit and save current message, then go to RUN
mode.
Control–S - Select message number.
ENTER - Save message being edited, and move on to the next
message.
ESC - Cancel current edit and return to run mode.
Control–E - Correct “EEPROM CRC ERROR” and return to run
mode.
Control–I - Initialize messages and return to run mode.
Note –Messages may also be entered/stored on floppy disk and downloaded
using a IBM PC or compatible with the Keypad Programming Software
(Catalog Number 2705–ND1). Refer to the Software User’s Manual
(Catalog Number 2705–ND003) for additional information.
Editing Commands