Rockwell Automation 2711-KA1_KC1_TA1_TA4_TC1_TC4 PanelView Terminals for DOS/Windows - Manual (Page 42)

PanelView 1200 Terminal Functions
Chapter 2
2-13
Touching the screen or keypad causes the current screen to reappear.
Mode changes, PLC generated Alarm Messages, Information Messages,
PLC generated screen requests, or terminal fault messages also turn off the
screen saver.
Screen Alignment
Choose Screen Alignment to set the position of the image on the terminal
display.
On a keypad terminal, use the function keys to change the alignment of a
screen. The function key nearest the Center Screen button sets the screen
alignment to its default position. The function keys nearest the Up, Down,
Left and Right buttons move the screen. The function key nearest the Save
& Exit button saves the current screen alignment and returns you to the
Configuration Mode Menu.
The following illustration shows the Screen Alignment screen for a keypad
terminal.
20155
ALIGN SCREEN
Left Right
Center
Screen Up Down
Save &
Exit
On a touch screen terminal, use the Test Alignment button to line up the
on-screen buttons with the touch cell borders. Press the four corners of the
Test Alignment button to see if it is properly aligned. If the button does not
light up when you press the corners, use the Up, Down, Left and Right
buttons to move the screen so that it does. Alignment is particularly
important with touch screen displays, especially if the terminal display will
be viewed at an angle.