Rockwell Automation 2711-KA1_KC1_TA1_TA4_TC1_TC4 PanelView Terminals for DOS/Windows - Manual (Page 52)

PanelView 1200 Terminal Functions
Chapter 2
2-23
The following illustration shows a Function Key Test screen.
20207
FUNCTION KEY TEST
Exit
Display tests the terminal’s display functions. The terminal shows
samples of the different character sizes and attributes, as well as the
terminal’s character set.
Before switching to Run mode, make sure you’ve downloaded an
application file, installed a user PROM containing one, or set the
Pass-Through Download address source to Manual. Without an application
file the PanelView 1200 terminal will show a major fault when it is
switched to Run mode and the Address Source is Application. When the
Address Source is Manual, the PanelView 1200 terminal will show the
Download in Progress screen when it is switched to Run mode.
To switch from Configure to Run mode, use the Mode Select Keyswitch on
the back of the terminal (see the rear panel illustration on page 2-1). If your
terminal is equipped with the Remote Keyswitch Assembly, you can
change modes from the front of the terminal.
Set the terminal to Run mode for everyday use. After downloading an
application file, the Powerup screen will be the first screen displayed the
first time the terminal is set to Run mode.
Run Mode Functions