Rockwell Automation 2711-KA1_KC1_TA1_TA4_TC1_TC4 PanelView Terminals for DOS/Windows - Manual (Page 47)

PanelView 1200 Terminal Functions
Chapter 2
2-18
23663
PASS-THROUGH
DOWNLOAD OPTIONS
>Auto Restart
>Address Source
>PLC Type
>Baud Rate
>Rack Number
>Starting Module
>Rack Size
>Last Chassis
>Module Group
>High/Low Byte
Up
Cursor
Save &
Exit
Manual
Address
Source
Down
Cursor
Change
Data
Yes
Application
PLCĆ5/250
230.4K
77
0
Full
Yes
7
High
Block
Transfer
Choosing Manual Address Source
will disable the Terminal's
current application file.
Select Application to enable.
On the keypad terminal, you can use the function keys to move the cursor.
F18 for Up Cursor
F19 for Down Cursor
F20 for Change Data
F21 for Save & Exit
Important On the keypad terminal, when Rack Number is selected and you
press the Change Data button, a keypad window opens. This window
disappears when you enter a valid rack number. On the touch screen
terminal, you can enter the Rack Number directly from the keypad when
Rack Number is selected. For both terminal types, the number must be in
Octal, and correspond to the PLC type selected.
Auto Restart
You can choose between Yes and No for the Auto Restart option. The
default is No.
If you choose Yes, PanelView 1200 will start executing the new
application file as soon as the download is completed.
If you choose No, PanelView 1200 will wait for operator confirmation
before it starts executing the new application.