Rockwell Automation 8520-OM Offline Development System User Manual - Manual (Page 40)

4--4 Configuring ODS
Publication 8520--UM051A--EN--P -- October 2000
Offline Development Manual (ODS) Software User Manual
If your are using Windows NT, ODS allows you to select your
default printer from a list of printers that are currently available to
your system. Use the
[F5] --Configuration pulldown menu to access
Print device setup .
Use this procedure to select your print device:
1. Select the Print device setup option from the
[F5] --Configuration menu. The following list box appears:
Select the appropriate baud rate for your serial communication
device. To abort this activity, select
<ESC> .
2. Select the appropriate print port for system. A checkmark
appears next to the current active choice. After you select a print
device, ODS saves it and makes this the default printer whenever
ODS is started. To cancel this selection, press
<ESC> .
ODS has a beeper that warns you when you press an illegal key or
when you attempt something that is not allowed. The
F5-Configuration menu lets you decide whether or not to use the
beeper.
Use this procedure to set the beeper:
1. Select [ F5 ] and pull down the F5-Configuration menu.
You can set the beeper to ON or OFF. A checkmark appears next
to the current active choice. If this is the first time ODS has been
configured, the check is next to
Beeper ON . After you make a
choice, ODS saves it and puts the beeper in that state whenever
ODS is started.
2. Select either Beeper ON or Beeper OFF .
The configuration menu disappears, but the beeper is set
according to the choice you made.
Configuring Print Device
(Windows NT only)
Turning the Beeper
ON/OFF