Rockwell Automation 8520-OM Offline Development System User Manual - Manual (Page 92)

7--18 Using ODS Communication Configuration
Publication 8520--UM051A--EN--P -- October 2000
Offline Development Manual (ODS) Software User Manual
12.Click on the Configure button next to TCP/IP to get RAS Server
TCP/IP configuration dialog.
13.Check the Entire Network button. If you are setting up the ODS
(client) computer, go to step 2 of the next section. If you are
setting up the 9/PC host (server) computer, go to the next step.
14.Check the Use static address pool button if you are assigning
static addresses. If you are using DHCP, click the Use DHCP
button and skip the next step.
15.Enter your starting IP address in the Begin box, and your ending
IP address in the End box.
16.Click OK. Click Continue to install RAS.
17.Click Close. When prompterd, reboot the computer.
These next steps assume that you set up accounts on the subject PC
for those users (or administrators) who will dial in to the server PC:
18.After logging into Windows NT,
A. Click the Windows NT Start button and select Programs.
B. Select Administrative Tools (Common).
C. Select Remote Access Admin.
19.Select Users → Permissions.
20.Click on the Users name (or administrator) who you want to
permit to dial in to the server. Check the Grant dialin
permission to user checkbox.