Rockwell Automation 9220-KTCT INSTL.INSTR CONTROLNET ISA/EISA - Manual (Page 13)

ControlNet ISA/EISA Bus Tool Installation Instructions 13
9220-5.1 — November 1996
Installing the Card Inside the Computer
Important: Make sure:
•
you know how to:
– install hardware in your computer
– configure the computer’s options before you install the card
•
the 9220-KTCT will fit in your computer—the card is 4.7” high and
does not fit in all computers
•
you consult your computer’s documentation for specific information
To install the card See this section
gather tools for installation Gather Tools for Installation, below
gain access to the computer’s
expansion slots Accessing the Computer’s Expansion Slots, below
insert the card into the computer Inserting the Card, on page 14.
Gather Tools for Installation
You need a Phillips-head or a flat-head screwdriver.
Accessing the Computer’s Expansion Slots
To install the 9220-KTCT, you access your computer’s expansion slots.
Using your computer’s hardware manual for instructions, you:
1. Power down the host computer. Turn off power switch.
2. Remove the computer’s central processing unit (CPU) cover.
3. Select a vacant 16- or 32-bit expansion slot.
Important: The 9220-KTCT will function only in a 16- or 32-bit
ISA/EISA expansion slot.
4. Remove the slot’s expansion cover by loosening the screw on the
back (rear bracket) of the computer.