Rockwell Automation 9220-KTCT INSTL.INSTR CONTROLNET ISA/EISA - Manual (Page 17)

ControlNet ISA/EISA Bus Tool Installation Instructions 17
9220-5.1 — November 1996
Connecting the Card
The 9220-KTCT has these components:
9220-KTCT
Network Access Port (NAP)
RJ-45 connector for connecting
programming terminals to
devices on a ControlNet network
Channel A
BNC connectors for connecting
directly to a ControlNet network
Channel B
Redundant media
BNC connectors
Diagnostic status
indicators
A
B
See page 22 for information
about status indicators.
Indicators diagnose only
redundant media
BNC connections.
!
ATTENTION: Do not use the 9220-KTCT card to
connect to more than one network at a time. Attempting to
connect to a second network will cause erratic operation of
your communication system.
If you are connecting the card See page
to a device already connected to the ControlNet network 18
directly to a ControlNet network, which requires a tap 20