Rockwell Automation 9220-KTCT INSTL.INSTR CONTROLNET ISA/EISA - Manual (Page 18)

ControlNet ISA/EISA Bus Tool Installation Instructions 18
9220-5.1 — November 1996
Connecting to a Device on the ControlNet Network
Using the network access cable (cat. no. 1786-CP), you can connect
your card to a ControlNet programmable controller, I/O adapter, or
communication interface.
!
ATTENTION: Use the 1786-CP cable when
connecting a programming terminal to the network
through NAPs; using another cable could result in possible
network failures.
1786-CP
9220-KTCT
programming
terminal
node
portable
host
computer 1784-KTC 9220-KTCT
desktop
host
computer
ControlNet link
1786-CP
Connecting a portable host computer to a
ControlNet link through a desktop host computer
Connecting a portable host computer to a ControlNet link
through a programmable controller or I/O adapter
ControlNet link
Important: The 1786-CP cable can be plugged into any ControlNet
product’s NAP to provide programming capability on the
ControlNet network. A programming terminal connected
through this cable is counted as a node and must have a
unique address.