Rockwell Automation 9220-KTCT INSTL.INSTR CONTROLNET ISA/EISA - Manual (Page 19)

ControlNet ISA/EISA Bus Tool Installation Instructions 19
9220-5.1 — November 1996
1. Connect one end of the 1786-CP to the NAP on the 9220-KTCT card.
9220-KTCT A B
9220-KTCT installed in 16-bit ISA- or
32-bit EISA-compatible computer
2. Connect the other end of the 1786-CP to the NAP on any other
ControlNet device connected via taps to the network.
This table shows the wiring for the 1786-CP cable.
Wire Number Signal Mnemonic Signal Name
1 ISO-GND Isolated Ground
2 N.C. No Connection
3 PTTX-H Transmit Data High
Co o 1
4 PTTX-L Transmit Data Low
Connector 1
5 PTRX-L Receive Data Low
6 PTRX-H Receive Data High
7 N.C. No Connection
8 ISO-GND Isolated Ground
1 ISO-GND Isolated Ground
2 N.C. No Connection
3 PTRX-H Receive Data High
Co o
4 PTRX-L Receive Data Low
Connector 2
5 PTTX-L Transmit Data Low
6 PTTX-H Transmit Data High
7 N.C. No Connection
8 ISO-GND Isolated Ground