Rockwell Automation 9220-KTCT INSTL.INSTR CONTROLNET ISA/EISA - Manual (Page 14)

ControlNet ISA/EISA Bus Tool Installation Instructions 14
9220-5.1 — November 1996
Inserting the Card
Following the card handling instructions on page 10, you:
1. Make sure you have correctly set all of the switches on the card.
2. Insert the card into the edge connector and tighten the
expansion-slot screw.
3. Turn on the computer to make sure it comes up correctly.
If the computer status is then
powers up correct go to step 4.
hangs up incorrect you may have to change switch settings
and cycle power.
won’t boot from hard drive examine Pentium/SCSI incompatibility
(if you have a Pentium processor).
4. Replace the CPU cover (when computer comes up correctly).