Rockwell Automation 9220-KTCT INSTL.INSTR CONTROLNET ISA/EISA - Manual (Page 21)

ControlNet ISA/EISA Bus Tool Installation Instructions 21
9220-5.1 — November 1996
!
ATTENTION: If you connect the 9220-KTCT to a
cable system that does not support redundant media,
connect the tap drop cable to the BNC connector labeled
channel A. Channel B is left open.
If the cable system is redundant, connect the product
such that all devices on the network use the same cable
for the same channel. That is, all channel A connectors
connect to one cable; all channel B connectors connect
to the other.
Connect the tap’s straight or right-angle connector To this channel on the card
from trunk cable A channel A
from trunk cable B channel B
tap on
trunk cable B tap on
trunk cable A
to
9220-KTC
T,
channel A to
9220-KTC
T,
channel B
2.