Rockwell Automation 9220-KTCT INSTL.INSTR CONTROLNET ISA/EISA - Manual (Page 16)

ControlNet ISA/EISA Bus Tool Installation Instructions 16
9220-5.1 — November 1996
4. Press any key.
You see a similar message:
Succeeded Make sure that the card is not connected to a network.
Succeeded Hard resetting KTCT.
Succeeded I/O Address: 220, Dual Port Address: D000:0000
Boot code version: 1.1 1/24/95, Serial #:
Main code version: 1.1 7/12/95
Succeeded Testing dualport interface
Waiting.. Soft resetting KTCT as network address ID 2. Press any key.
5. Press any key.
You see a similar message:
Succeeded Soft resetting KTCT as network address 2.
Waiting.. Setting KTCT to online. Press any key.
6. Press any key.
You see:
Succeeded Setting KTCT to online. KTCT LEDs should show flashing red.
Waiting.. Setting KTCT to offline. Press any key.
7. Press any key
You see:
Succeeded Setting KTCT to offline. KTCT LEDs should show flashing green.
Waiting.. Resetting KTCT. Press any key.
8. Press any key.
You see:
Succeeded Resetting KTCT. KTCT LEDs should alternate green and red.
Test of KTCT’s basic functionality succeeded. Installation successful.