Rockwell Automation 1901 SyncPro - Manual (Page 17)

Chapter
2
Receiving and Storage
Receiving Upon receiving the controller, remove the packing and check for
damage that may have occurred during shipping. Report any
damage immediately to the claims office of the carrier.
NOTE: If the SyncPro is an integral component of a brush-type
synchronous starter (Bulletin 1912B), special receiving and
handling instructions will apply. For details, refer to the service
manual provided with the equipment.
Storage It is important to consider the following storage requirements if
you are not installing your controller immediately after receiving it.
• Store the controller in a clean, dry, dust-free environment.
• Storage temperature should be maintained between -20°C and
70°C (-4°F and 158°F).
• Relative humidity must not exceed 95%, non-condensing.
1901-UM020C-EN-P – June 2013