Rockwell Automation 8520-OM Offline Development System Software - Manual (Page 17)

2–4 Installing ODS
Publication MCD-5.1 -August 1999
The installation utility installs the files from disk 1 onto the hard
disk and displays this message:
Phase 2 Installation will now be invoked.
If the message “Bad command or filename”
appears, it means that the DOS command
processor (COMMAND.COM) could not be located.
Make sure your PATH command includes the
directory that COMMAND.COM resides in. Then
re-start this Installation procedure.
See your DOS manual for further information.
Strike a key when ready . . .
6. Press any key to start Phase 2 of the installation utility.
The computer displays:
Copyright 1989-1999 Allen-Bradley Company
Installation program - Phase 2
Installing ODS for Model 9/Series (archive
version)...
When the installation utility finishes installing all of the files
from disk 1, the computer displays this message:
Insert Disk # 2
Strike a key when ready . . .
7. Remove disk 1 from drive A, and insert disk 2.
8. Press any key to continue the installation process.
The screen displays this message:
Installing Disk # 2
9. After all of the files from disk 2 are installed, repeat the process
for each of the remaining disks.
10.Select your options. ODS installs the products that you selected.
After you complete the installation process, the ODS displays
this message:
Insert Disk # 1
Press any key to continue...
11. Remove the floppy disk from drive A, and insert disk 1. Press
any key to continue.
The installation utility displays a message similar to this:
ODS supports most IBM 100% compatibles,
however, some use unusual video monitors.
Please select the type of computer this
version of ODS will be running on:
1) 100% compatible or Allen-Bradley
T35/T47/T50/T60
2) Allen-Bradley T45
3) COMPAQ Portable 386
Enter selection (1/2/3):