Rockwell Automation 8520-OM Offline Development System Software - Manual (Page 85)

7–11 Using ODS Communication Configuration
Publication MCD-5.1 -August 1999
Use the following instructions to configure DH+ under Windows NT
via ODS:
1. In your Windows NT application, launch ODS in a DOS shell.
With RSLinx running, follow steps 1 through 4 as described in
Creating a Project (refer to Chapter 5).
2. Select DH+ Network as your application type by choosing <D> .
3. When the system prompts you for your desired driver type,
RSLinx is selected by default. Choose <F> to continue to the next
screen.
4. A list box containing DH+ drivers that are currently configured in
RSLinx appears. Select the name corresponding to your
configured driver.
Configuring DH+ Under
Windows NTt In ODS