Rockwell Automation 8520-OM Offline Development System Software - Manual (Page 44)

5–3 Using ODS for Project Management
Publication MCD-5.1 -August 1999
4. Select a control type.
If you select one of the 9/Series controls, a similar screen
appears:
5. If applicable, select an application type. For this example, we
chose (a) .
ODS asks you to determine the type of communication required
for your control.
Important: For standard RS232 communication, select
(C) .
For use with the DH+ network, select (D) . If
you are using OCI, you can either select the
Ethernet
(E) or Control Serial Port (C) option.
Important: Accessing DH+ using DOS or Windows 95 with
your 9/Series control requires INTERCHANGE.
Accessing DH+ via Windows NT requires
RSLinx. Refer to Chapter 7 for more
information about the configuration menu flow
for INTERCHANGE and RSLinx with DH+.
Important: The Ethernet/OCI communication mode is only
available for the 9/260 and 9/290 CNCs.
Accessing Ethernet requires Windows NT and
RSLinx. Refer to Chapter 7 for more
information about the configuration menu flow
for INTERCHANGE and RSLinx with DH+.