Rockwell Automation 8520-OM Offline Development System Software - Manual (Page 40)

4–5 Configuring ODS
Publication MCD-5.1 -August 1999
When the verify feature is set to ON , ODS displays a screen when you
select the Delete file option:
To delete a file, select [ Y ]. If you select [ N ], ODS aborts the delete
operation. This gives you the opportunity to cancel a delete
operation after selecting it.
If the verify feature is OFF, ODS does not display the OK to delete
this file ? box before deleting a file.
The F5-Configuration menu lets you turn the Verify feature ON or
OFF. Use this procedure to configure the
Verify feature:
1. Select [F5] and pull down the F5-Configuration menu.
Notice that there are two choices for Verify ON or Verify OFF .
A check mark appears next to the current active choice. If ODS
is being configured for the first time, the checkmark appears next
to Verify ON.
2. Select either Verify ON or Verify OFF
.
After you make a choice, ODS saves your selection, and puts the
Verify feature in that state whenever ODS is started up.
The configuration menu disappears, but the Verify feature is
turned ON or OFF according to the choice you made.
Turning the Verify Feature
ON/OFF