Rockwell Automation 8520-OM Offline Development System Software - Manual (Page 20)

2–7 Installing ODS
Publication MCD-5.1 -August 1999
When selecting any other CONFIG.SYS commands, be aware of
the memory requirements.
2. Reboot the computer to read the data from this file.
If you are using a DOS–based system, you can directly start ODS.
You must modify the PATH command in the AUTOEXEC.BAT file
by adding this entry to the path:
;C:\IMC
If you want ODS to start automatically when you turn on the
computer, add this entry to the last line of the AUTOEXEC.BAT file:
IMC
Refer to the computer’s DOS manual for further instructions.
If for any reason you need to remove the ODS software from the
computer’s hard disk, use the following procedure:
Important: This procedure assumes that the floppy-disk drive is
drive A and the hard-disk drive is drive C. If the drive
designations on your computer are different, substitute
the appropriate designations.
Important: Before you remove the ODS software from the hard
disk, back up any projects you need to save, then delete
all of the projects.
1. Insert ODS disk 1 in floppy-disk drive A.
2. If you are at the C: prompt, type:
a:
and press [ENTER] .
3. At the prompt, type:
a:remove
and press [ENTER] .
The removal utility displays this message:
Modifying the
AUTOEXEC.BAT File
Removing the ODS
Software