Rockwell Automation T8094 8000 Series TMR System Safety Manual - Manual (Page 99)

SAFETY MANUAL
D oc N umber T8094
I ssue 27 – June 2013
Page 78 of 103
Item Description Part No. /
Revision Remarks
4 PI-110/C PI-M cooling module 001-1010-02
5 PM108 D/C power supply digital termination (24V
DC) 001-1039-00
… chassis 031-1005-02
… power supply module 031-1004-01
6 TM118-TWD triplicated watchdog timer 001-1032-00
7 PI-716 digital input board 099-1045 AK6 certified 3-2-0 and
3-2-1
8 PI-726 digital output board 099-1078
9 PI-727 digital output board 099-1043 AK6 certified 3-2-1
10 PI-732 analogue input board (5V unipolar) 099-1042
11 PI-616 digital input board 099-1124 AK6 certified 3-2-0 and
3-2-1
12 PI-626 digital output board 099-0084
13 PI-627 digital output board 099-0074 AK6 certified 3-2-1
14 PI-632 analogue input board (5V unipolar) 099-1105
15 TM-117-RME termination panel digital output
monitor (24V DC) 099-1094-00 Only use in dual tested
configurations
16 TM-118-D digital termination panel (24V DC) 099-1003 Only use in dual tested
configurations
17 TM117-SME digital output testing 099-1097/8/9
18 TM117-DC digital input 099-1000
19 TM118-DH digital input 099-1157
20 TM119-DH digital input 099-1152
Note: The PI-641 and PI-741 analogue output modules and their associated
termination panels are also supported by the migration, but for only non-safety
applications. Therefore, there are no function blocks associated with these modules.
9.5 REQUIREMENTS FOR THE TRUSTED TM SYSTEM
The Trusted TM system requires at least a controller assembly and a power system, and
possibly an expander system as well. The controller assembly has a T8100 controller
chassis to house the essential modules:
• One T8110 TMR processor.
• One T8311 expander interface modules to provide the interface between the
controller chassis and the CS300 chassis.
• One T8151B communication interface for the Ethernet interface to the engineering
workstation and, if present, other Trusted
TM systems or third-party equipment.
• One T8153 communications interface adapter, to allow the physical connections to
the T8151B communication interface.
The T8100 controller chassis must be installed in a rack with doors and side panels,
and the doors must be kept closed during usual operation. This lets the 8162 Bridge
Module achieve compliance with its EMC specifications with no degradation in
performance. The front door can have a window so that the LEDs are visible.The
CS300 equipment must be inside the cabinet and earthed correctly (see Sections
3.13.3.2 to 3.13.3.4).