Rockwell Automation FactoryTalk AssetCentre Machine Edition Installation Manual - Manual (Page 22)

F ACTORY T ALK A SSET C ENTRE M ACHINE E DITION I NSTALLATION G UIDE
18
• •
•
•
•
8. On the final page of the FactoryTalk AssetCentre Server InstallShield Wizard, click
Finish.
FactoryTalk AssetCentre Common Components installer
See “Installing FactoryTalk AssetCentre Machine Edition software” on page 13 for the steps to
get to this part of the installation.
To install the common components:
1. Follow the on-screen instructions.
2. When asked to restart your computer, click Yes. You must restart the computer before
you run the FactoryTalk AssetCentre Machine Edition server.
3. If you see messages indicating that the firewall has blocked a program, select
Unblock on each message.
A
FTER REBOOTING
The installation software initiates each component install again in sequence beginning
with the FactoryTalk Services Platform. You can cancel the installation for all
components that you have already installed. The list below provides a step-by-step
sequence to cancel all installs that have been completed to this point. What you see may
vary depending on your particular system.
1. Click Start on the Install FactoryTalk AssetCentre Machine Edition window.
2. Depending on your FactoryTalk Directory setting, you may see the stop sign window
again about how to set the FactoryTalk Directory. See step 4 on page 15 to make the
appropriate choice.
3. Click Continue on the Check FactoryTalk Services Platform Configuration window.
This proceeds to the next segment of the installation.
FactoryTalk AssetCentre Client installer
See “Installing FactoryTalk AssetCentre Machine Edition software” on page 13 for the steps to
get to this part of the installation.
After rebooting, the setup program starts the installation for the FactoryTalk AssetCentre
client software. This component provides the interface, the part of the software that you
interact with.
Depending on the speed of your computer, you may see the Install FactoryTalk AssetCentre
server window for a moment after you restart and log back onto your server computer. This
behavior is normal (the installation program checks to see if everything is installed correctly
before proceeding).